A pre-owned unit that is fully refurbished to a very high standard. This device is around 750mm in overall width subject to motor selection which suits a wide range of larger machine tool bed widths and an overall height of 295mm. The unit has a standard tilting range of zero to + 105 degrees. An excellent carrying capacity of 50kg through the whole tilting range and 80kg horizontally or between centres and speeds of up to 22. 2rpm in the rotary axis and 11. 1rpm in tilt dependent on motor selection. (Based on a 2,000rpm motor) Net weight of this device is around 210kg. The Nikken 5AX-200 CNC rotary tilting table without motors, can be prepared to suit any interface at additional cost (see our interface listings for details and costs for “external interface” (motor, switch, cable and connector requirements if you already have a “4th / 5th axis interface” in the machine) and machine interface costs (if you do not have the additional axes fitted). Rotary axis motor is mounted to the right hand side on this device and may restrict the Y axis capability in certain circumstances, the tilt axis motor is mounted in a rear facing direction on the far side of the device and should not have any bearing on traverses. This range of Nikken devices come with a carbide worm and specially treated hardened wheel, which means that backlash adjustments may be on an extended time frame to that of a device with say a bronze wormwheel. Nikken is a leading class manufacturer from Japan and in our experience build a very fine device with a very long service life.